Vulcanization kinetics for a natural rubber compound were studied by a kinetic approach using the cure meter and DSC methods. A simplified but realistic model reaction scheme was used to simulate induction, curing, and overcure periods continuously. Physically significant parameters of the model were extracted from isothermal experimental data using a cure meter. The calculation demonstrated a good correspondence with isothermal cure meter data over the temperature range studied. The length of induction time, variation of maximum modulus with temperature, and the reversion phenomena observed from cure curves can be predicted. DSC data were found to be incompatible with the cure meter test, because the complex vulcanization reaction system is multiexothermal and it is difficult to isolate the heat due to crosslinking. Hence, the cure meter technique is suggested for the study of crosslink formation. The kinetic approach provides a way to incorporate vulcanization kinetics into simulation of reactive processing operations.