Crystalline silicon wafers are by far the dominant absorber materials for today's production of solar cells and modules due to their good price/performance relation and their proven environmental stability. These wafers are mainly produced either by a solar-optimized Czochralski (Cz)-growth method yielding crystalline silicon with low defect density (c-Si) or by a directional solidification or a ribbon growth method yielding large grained multi-crystalline (mc-Si) wafers with higher defect density. To further improve the price/performance relation of Cz solar cells, tri-crystalline silicon (tri-Si) is being developed as a high-quality wafer material that combines both the high diffusion length of minority carriers of up to 1300 mum of c-Si and the productivity of me-Si. More than 1000 mum LID free diffusion length could be reached with specially doped tri-crystals. Due to an increased mechanical stability tri-Si allows both quasi-continuous pulling and thin slicing with higher mechanical yields. This paper reviews the structural, electronic, and mechanical properties of tri-crystalline silicon wafers with respect to c-Si wafers for solar applications. Actual non-textured solar cells processed with a simple cost effective fabrication process exhibit the same cell efficiencies up to 15.9 % for both tri-silicon and mono-silicon wafers. With an improved process, up to 18% cell efficiency can be obtained with textured mono-Si. (C) 2002 Elsevier Science B.V. All rights reserved.