An asymmetric compound parabolic photovoltaic concentrator (ACPPVC) of geometrical concentration ratio 2 was designed, developed and evaluated for building facade integration. Despite the two times theoretical concentration, the maximum output power achieved was only 1.62 times that of a similar non-concentrating system for a wide range of solar radiation intensities due to a combination of optical and electrical resistance losses. In this paper, the power loss of the ACPPVC system is explained by a comparative power loss analysis of the non-concentrating photovoltaic system for long- and short-tabbed solar cell strings that showed an average of 3.4% electrical power loss due to resistance in the interconnections between each individual solar cell. The optical losses of the ACPPVC were 15% caused by the combined effect of the number of reflections at the reflectors and the misalignment of the imperfection in the reflector geometry solar cells in addition to the power loss due to increased temperature of 0.6%. Good agreement was found between the measured and calculated optical efficiency of the system. (c) 2007 Elsevier B.V. All rights reserved.