In this study, the cathodic arc evaporation technique, by using the chromium target and controlling the flow rate of nitrogen/oxygen reactive gases, was utilized to deposit three different Cr-N-O coatings (CrN, CrN/Cr (N,O), CrN/Cr(2)O(3)) on AISI M2 tool steel. Two types of wear tests were applied to evaluate the abrasive and erosive wear behavior of the coated and uncoated specimens. One was the ball-on-disk abrasion test to measure the friction coefficient of these specimens. The other was the erosion test using Al(2)O(3) particles (similar to 177 mu m in size and Mohr 7 scale) of about 5 g, and then the surface morphologies of the eroded specimens were observed. To further understand the coating effects on the two wear behaviors of M2 steel, coating structure, morphology, and adhesion were analyzed using XRD, SEM, and TEM, respectively. The results showed that surface roughness and adhesion of the double-layered coatings (CrN/Cr(N,O) and CrN/Cr(2)O(3)) were inferior to those of monolithic CrN, but their hardness and elastic modulus were superior to those of CrN. In the abrasive behavior, Cr-N-O coatings reduced the friction coefficient of M2 substrate. In particular, the CrN/Cr(2)O(3) has the highest hardness/elastic (H/E) modulus ration, therefore the lowest friction coefficient, among all the coated-specimens tested. In the erosive behavior, the coated specimens exhibited better erosion resistance as compared to the uncoated ones, at the impingement angles of either 30 degrees or 90 degrees. Moreover, the erosion resistance of CrN/Cr(N,O) coatings was superior to that of CrN/Cr(2)O(3) coatings due to its better adhesion. (C) 2008 Elsevier B.V. All rights reserved.