Minimum film-formation temperature (MFFT) of vinylidene chloride (VDC)-methyl acrylate (MA) copolymer latexes prepared by batch emulsion polymerization with various compositions from 20 to 97 wt % of VDC were measured. For latexes with VDC content below 90 wt %, MFFT was similar to polymer T-g. As VDC content increased beyond 90 wt %, the MFFT curve plotted against VDC content rose sharply, in contrast with the T-g curve that descended smoothly. Measurements of infrared absorption of latexes in the dispersed state, and X-ray diffraction and infrared absorption of lyophilized polymers were conducted on 40 : 60, 80 : 20, and 95 : 5 VDC-MA specimens. These observations indicated that only 95 : 5 VDC-MA specimens were highly crystalline. It was therefore believed that film-formation property of latex with high VDC content was significantly affected by polymer crystallinity of particles in the dispersed state. Morphology and oxygen gas transmission rate of heat-treated and non-heat-treated coatings of 95 : 5 VDC-MA latex were Investigated. Heat treatment of coatings beyond the temperature at, which crystalline polymer began to melt induced effective particle coalescence, resulting in reduced oxygen gas transmission rate. This supported our belief that film-formation property of VDC-MA latex with high VDC content was significantly affected by polymer crystallinity.