화학공학소재연구정보센터
Thin Solid Films, Vol.519, No.11, 3501-3508, 2011
Role of argon in hot wire chemical vapor deposition of hydrogenated nanocrystalline silicon thin films
Structural, optical and electrical properties of hydrogenated nanocrystalline silicon (nc-Si:H) films, deposited from silane (SiH4) and argon (Ar) gas mixture without hydrogen by hot wire chemical vapor deposition (HW-CVD) method were investigated. Film properties are carefully and systematically studied as a function of argon dilution of silane (R-Ar). We observed that the deposition rate is much higher (4-23 angstrom/s) compared to conventional plasma enhanced chemical vapor deposited nc-Si:H films using Ar dilution of silane (0.5-0.83 angstrom/s). Characterization of these films with Raman spectroscopy revealed that Ar dilution of silane in HW-CVD endorses the growth of crystallinity and structural order in the nc-Si:H films. The Fourier transform infrared spectroscopic analysis showed that with increasing Ar dilution, the hydrogen bonding in the films shifts from di-hydrogen (Si-H-2) and (Si-H-2)(n) complexes to mono-hydrogen (Si-H) bounded species. The hydrogen content in the films increases with increasing Ar dilution and was found to be < 4 at.% over the entire range of Ar dilutions of silane studied. However, the band gap shows decreasing trend with increase in Ar dilution of silane and it has been attributed to the decrease in the percentage of the amorphous phase in the film. The microstructure parameter was found to be > 0.4 for the films deposited at low Ar dilution of silane and similar to 0.1 or even less for the films deposited at higher Ar dilution, suggesting that there is an enhancement of structural order and homogeneity in the film. From the present study it has been concluded that the Ar dilution of silane is a key process parameter to induce the crystallinity and to improve the structural ordering in the nc-Si:H films deposited by the HW-CVD method. Crown Copyright (C) 2011 Published by Elsevier B.V. All rights reserved.