Samples of each of two high-density polyethylenes with various initial degrees of crystallinity, but otherwise identical, were exposed under a vacuum to moderate doses of gamma irradiation. The results indicate that, for otherwise initially identical polymer samples, the dose required to reach the gel point increases with increase of the initial degree of crystallinity. Above the critical dose for gelation, the gel content decreases with higher degrees of crystallinity at equal radiation doses. The mechanical behavior of the polymers changed progressively from ductile to brittle as the crystallinity was increased. The extensibility of originally ductile samples decreases with increasing radiation dose. The irradiation of samples having intermediate behavior produces a change to ductile behavior. Mechanical behavior is not modified substantially when brittle samples are irradiated. The initial modulus is little altered by irradiation, while the yield stress shows a slight increase with irradiation. The mechanical properties, such as draw ratio at break and ultimate tensile stress, decrease with dose in ductile samples.