International Journal of Heat and Mass Transfer, Vol.55, No.25-26, 7892-7901, 2012
Investigation of natural convection induced outer side heat transfer rate of coiled-tube heat exchangers
Natural convection induced heat transfer has been studied over the outer surface of helically coiled-tube heat exchangers. Several different geometrical configurations (curvature ratio delta is an element of [0.035, 0.082]) and a wide range of flow parameters (60 <= T-tank <= 90, T-in = 19 and 60 <= T-in <= 90, T-tank = 20, 4000 <= Re <= 45000) have been examined to broaden the validity of the results gained from this research. A fluid-to-fluid boundary condition has been applied in the numerical calculations to create the most realistic flow configurations. Validity of the numerical calculations has been tested by experiments available in the open literature. Calculated results of the inner side heat transfer rate have also been compared to existing empirical formulas and experimental results to test the validity of the numerical computation in an independent way from the outer side validation of common helical tube heat exchangers. Water has been chosen to the working fluid inside and outside of the coiled tube (3 < Pr < 7). Outer side heat transfer rate along the helical tube axis has been investigated to get information about the performance of the heat transport process at different location of the helical tube. It was found that the outer side heat transfer rate is slightly dependent on the inner flow rate of any helical tube in case of increasing temperature differences between the tank working fluid temperature and the coil inlet temperature. A stable thermal boundary layer has been found along the axial direction of the tube. In addition to this the qualitative behavior of the peripherally averaged Nusselt number versus the axial location along the helical tube function is strongly dependent on the direction of the heat flow (from the tube to the storage tank and the reversed direction). Inner side heat transfer rate of helical coils have also been investigated in case of fluid-to-fluid boundary conditions and the calculation results have been compared with different prediction formulas published in the last couples of decades. (C) 2012 Elsevier Ltd. All rights reserved.