Liquefied wood (LW) is a naturally based product which has the potential to be used as an adhesive. It can be used as a part of a polymer formulation, as a part of an adhesive mixture with commercial adhesives, or as an independent material for wood bonding. In this study, wood was liquefied at 180 degrees C using ethylene glycol as the solvent and sulphuric acid as a catalyst. In the first part of research, LW with different pH values was used for the bonding of solid wood at 200 degrees C for 15min. In the second part, LW with an optimal pH value was used for bonding at different press temperatures for 15min. In the third part, the minimum pressing time at the optimal pH value and at the optimal press temperature was determined. Unmodified LW with a negative pH value, a press temperature of 180 degrees C, and a pressing time of 12min was determined to be optimal (based on highest shear strength) for the bonding of 5mm thick wood lamellas with the LW used in this study. At these conditions bonds exhibited shear strength of around 7N/mm2 which was too low to attain standard requirements. Despite this, high wood failure (100%) was observed as a consequence of low pH value and high press temperature which caused damage of the part of beech lamellas where LW was applied.