Poly(ethylene glycol)/polylactic acid (PEG/PLA) nanoparticles (NPs) containing the hydrophobic antifungal itraconazole (ITZ) were developed to provide a controlled release pattern of ITZ as well as to improve its aqueous dispersibility and hence enhance its antifungal action. Two PEG/PLA copolymers (PEGylated PLA polymers) were used in this study; branched PEGylated polymer in which PEG was grafted on PLA backbone at 7% (mol/mol of lactic acid monomer), PEG7%-g-PLA, and multiblock copolymer of PLA and PEG, (PLA-PEG-PLA)n with nearly similar PEG insertion ratio and similar PEG chain length. ITZ-loaded PLA NPs were also prepared and included in this study as a control. ITZ-NPs were prepared from a 1:1 w/w blend of PLA and each PEGylated polymer either PEG7%-g-PLA or (PLA-PEG-PLA)n using an oil-in-water emulsion evaporation method. The NPs morphology, size and size distribution, zeta potential, loading efficiency, release profile and antifungal activity were characterized. All ITZ-NPs were nearly spherical with smooth surface and showed less aggregating tendency with a size range of 185-285 nm. All ITZ-NPs measured nearly neutral zeta potential values close to 0 mV. The % LE of ITZ was similar to 94% for PEG7%-g-PLA NPs and similar to 83% for (PLA-PEG-PLA)n at 15.3% w/w theoretical loading. PEG/PLA NPs were stable over time regarding size and size distribution and % ITZ loading efficiency (% LE). ITZ release showed an initial burst followed by a gradual release profile for ITZ-NPs over 5 days. (PLA-PEG-PLA)n NPs exhibited faster release rates than PEG7%-g-PLA NPs particularly at the last 2 days. Differential scanning calorimetry and powder X-ray diffractometry data confirmed that ITZ exists in an amorphous state or a solid solution state into the NPs matrix. Fourier transform infrared revealed the possibility of chemical interaction between ITZ and the NPs matrix polymer indicating the successful entrapment of ITZ inside the particles. In haemolysis test, ITZ-NPs caused mild haemolysis over the concentration range (5-20 mg/mL) compared to free ITZ, indicating better safety profile of ITZ-NPs. ITZ-loaded PEG/PLA NPs inhibited fungal growth more efficiently than either free ITZ or ITZ-loaded PLA NPs. Our results suggest that PEG/PLA-ITZ could be used efficiently as a nanocarrier to improve the aqueous dispersibility of ITZ, control its release over time and, thereby, enhance its antifungal efficacy.