Promising hybrid processes for ethanol dewatering consist of different combinations of distillation with adsorption and/or vapour permeation. This paper presents an analysis and optimisation of these hybrid processes using non-equilibrium models and an evolutionary algorithm. Four different membrane assisted configurations are compared with a benchmark process consisting of distillation and pressure swing adsorption. In total 12 cases were investigated while assuming different feed and product compositions at different production capacities: three ethanol mass fractions in feed 45, 80, 92 wt.%, two product purities 99.6, 99.95 wt.% and two production capacities 25,000, 250,000 m(3)/year. The influence of decisive operating and structural variables on important target variables such as total membrane area is demonstrated. Finally, the processes are evaluated regarding operating costs and energy consumption depending on product purity and production capacity. The operating costs of the membrane assisted configurations differ only in a small range of -3% to 6% from those of the benchmark. The energy consumption of the membrane assisted configurations without distillation is up to 30% lower compared to the benchmark. Especially the combination of vapour permeation and adsorption is a promising alternative allowing for producing ethanol with high purities at lower operating pressures compared to the vapour permeation as stand alone process. (C) 2013 The Institution of Chemical Engineers. Published by Elsevier B.V. All rights reserved.