In this study, we investigated the draping behavior of jute woven fabric to study the feasibility of using natural fabrics in place of synthetic glass-fiber fabrics. Draping behavior describes the in-mold deformation of fabrics, which is vital for the end appearance and performance of polymer composites. The draping coefficient was determined with a common drapemeter for fabrics with densities of 228-765 g/m(2) and thread counts under different humidity and static dynamic conditions. The results were compared to glass-fiber fabrics with close areal densities. Characterization of the jute fabrics was carried out to fill the knowledge gap about natural-fiber fabrics and to ease their modeling. The tensile and bending stiffnesses and the shear coupling were also characterized for a plain woven jute fabric with a tensile machine, Shirley bending tester, and picture frame, respectively. As a case study, the draping and resin-transfer molding of the jute fabric over a complex asymmetric form was performed to measure the geometrical conformance. The adoption of natural fibers as a substitute for synthetic fibers, where the strength requirements are satisfied, would thus require no special considerations for tool design or common practices. However, the use of natural fibers would lead to weight and cost reductions. (c) 2013 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 130: 1453-1465, 2013