Tin oxide films have been prepared by oxidation of Sn thin films deposited by thermal evaporation method onto glass substrates. The oxidation of films was done, in air at a temperature of 500 degrees C, from 20 to 120 min. The oxidized films were characterized by X-ray diffraction (XRD), Rutherford backscattering spectroscopy (RBS), photoluminescence spectroscopy (PL) and surface profilometer. The XRD patterns show that the crystalline structure of the oxidized Sn films improves with the annealing time. The tetragonal SnO2 phase (cassiterite) was obtained after 120 min of annealing with grains sizes between 15 and 20 nm. The thickness of oxide films, as function of the annealing time, follows a parabolic law. The O/Sn atomic ratio increases with the annealing time indicating an improvement of the films quality. Tin interstitials defects density, calculated from PL spectra using Smakula's formula, was found to decrease with the increasing annealing time. Tin interstitials defects density was found proportional to the increasing oxygen density (deduced from RBS). A fit of this proportionality allowed us to quantify the tin cations and oxygen anions diffused through the oxide films. (C) 2013 Elsevier B. V. All rights reserved.