The solution behavior of a DTPA (diethylenetriamine pentaacetic acid)-based chelating surfactant, 4-C-12-DTPA, has been studied by tensiometry and NMR diffusometry. In the absence of metal ions, the eight donor atoms in the headgroup are titrating, and the charge of the headgroup can thus be tuned by altering the pH. 4-C-12-DTPA changes from cationic at very low pH, over a number of zwitterionic species as the pH is increased, and eventually becomes anionic at high pH. Around the isoelectric point, the chelating surfactant precipitated. The solution properties, studied above the solubility gap, were found strongly pH dependent. When increasing the amount of negative charges in the headgroup, by increasing the pH, the adsorption efficiency was reduced and the cmc was increased. An optimum in surface tension reduction was found at pH 5, due to a proper balance between protonated and dissociated groups. Anomalies between surface tension measurements and NMR diffusometry in determination of cmc revealed a more complex relation between surface tension, surface coverage, and cmc than usually considered, which is not in line with the common interpretation of the Gibbs adsorption equation. At some of the investigated pH levels, measurements of bulk pH could confirm the location of cmc, due to the increased protonation of micelles compared to monomers in solution. The adsorption of monomers to the air-water interface showed unusually slow time dependence, evident from decreasing surface tension for several hours. This is explained by rearrangements of the large head groups to reduce the headgroup area and increase the packing parameter.