Carbon nanotubes (CNTs) have been proven to be possible as high-value by-products of hydrogen production from gasification of waste plastics. In this work, steam content in the gasification process was investigated to increase the quality of CNTs in terms of purity. Three different plastics low density polyethylene (LDPE), polypropylene (PP) and polystyrene (PS) were studied in a two stage pyrolysisgasification reactor. Plastics samples were pyrolysed in nitrogen at 600 degrees C, before the evolved gases were passed to a second stage where steam was injected and the gases were reformed at 800 degrees C in the presence of a nickel-alumina catalyst. To investigate the effect that steam plays on CNT production, steam injection rates of 0, 0.25, 1.90 and 4.74 g h(-1) were employed. The CNTs produced from all three plastics were multiwalled CNTs with diameters between 10 and 20 nm and several microns in length. For all the plastic samples, raising the steam injection rate led to increased hydrogen production as steam reforming and gasification of deposited carbon increased. High quality CNTs, as observed from TEM, TPO and Raman spectroscopy, were produced by controlling the steam injection rate. The largest yield for LOPE was obtained at 0 g h(-1) steam injection rate, whilst PP and PS gave their largest yields at 0.25 gh(-1). Overall the largest CNT yield was obtained for PS at 0.25 g h(-1), with a conversion rate of plastic to CNTs of 32 wt%. (C) 2013 Elsevier B.V. All rights reserved.