Micropollutants in groundwater are given significant attention by water companies and authorities due to an increasing awareness that they might be present even above the legal threshold values. As part of our investigations of the possibility to remove the common groundwater pollutant 2,6-dichlorobenzamide (BAM) by introducing the efficient BAM degrader Aminobacter sp. MSH1 into biologically active sand filters, we investigated if the strain adheres to filters containing various filter materials and if the initial adherence and subsequent degradation of BAM could be optimized. We found that most of the inoculated MSH1 cells adhered fast and that parameters like pH and ionic strength had only a minor influence on the adhesion despite huge influence on cell surface hydrophobicity. At the given growth protocol, the MSH1 strain apparently developed a subpopulation that had lost its ability to adhere to the filter materials, which was supported by attempted reinoculation of non-adhered cells. Analysis by quantitative PCR showed that most cells adhered in the top of the filters and that some of these were lost from the filters during initial operation, while insignificant losses occurred after 1 day of operation. The inoculated filters were found to degrade 2.7 mu g/L BAM to below 0.1 mu g/L at a 1.1-h residence time with insignificant formation of known degradation products. In conclusion, most filter materials and water types should be feasible for inoculation with the MSH1 strain, while more research into degradation at low concentrations and temperatures is needed before this technology is ready for use at actual waterworks.