Local bubble characteristics, including gas holdups, bubble rise velocities, and chord lengths, were measured using a monolibre optical probe manufactured to withstand elevated pressures. Previous studies have validated the use of single tip probes for simultaneous measurement of local bubble properties at atmospheric conditions; however no study has been currently reported for these probes at elevated pressures. Experiments were conducted in a 101.6 mm diameter column operating at pressures up to 9.0 MPa. Surfactant addition and operating pressure were studied to simulate high gas holdups observed in many industrial reactors containing liquid mixtures with surface-active compounds. Experiments were hence completed using two liquid phases: tap water and a 0.5 wt% aqueous ethanol solution. Liquid and gas superficial velocities were varied between 0-90 mm/s and 0-150 mm/s, respectively. Radial profiles at atmospheric conditions validated the probe measurements in water. Local holdups, rise velocities and chord lengths were adequately measured in water up to 9.0 MPa. The probe struggled in the aqueous ethanol solution due to its physical constraints (i.e., Lip diameter and sensing length) when compared to the significant bubble size reduction (chord lengths below 0.5 mm). Comparisons with fluidized bed freeboard measurements demonstrated that flow through the bed enhanced bubble breakup for a coalescing system, but had a negligible impact with the added surfactant. (C) 2014 Elsevier Ltd. All rights reserved.