This study presents information obtained by the synthesis of Fe(3) oxide/hydroxide nanoparticles sal (NanoFe) and NanoFe-impregnated granular activated carbon as adsorbents for boron removal from solutions. The research describes an adsorption method for cleaning a solution containing boron contaminants followed by recovery of the adsorbent and the adsorbed material for safe removal or further reuse. The technology provides an efficient method of boron removal from water. A marked effect of NanoFe and NanoFe-impregnated GAC adsorbents concentration and pH level on boron removal efficiency was demonstrated. At least 95-98% boron recovery efficiency is possible using NanoFe sol and Fe-impregnated GAC that in fact also recover the adsorbent for reuse. Boron adsorption onto the NanoFe-impregnated GAC adsorbent may be described by pseudo-second-order reaction kinetics and the Langmuir isotherm model. The boron adsorption capacity on iron (3) oxide nanoparticles and Fe-impregnated GAC at an equilibrium concentration of 0.3 mg/dm(3) as B in the solution is much higher than these values for similar adsorbents reported in the literature. (C) 2013 Elsevier B.V. All rights reserved.