The burning rates and surface characteristics of hydrogen-enriched turbulent lean premixed methane-air flames were experimentally studied by laser tomography visualization method using a V-shaped flame configuration. Turbulent burning velocity was measured and the variation of flame surface characteristics due to hydrogen addition was analyzed. The results show that hydrogen addition causes an increase in turbulent burning velocity for lean premixed CH(4)-air mixtures when turbulent level in unburned mixture is not changed. Moreover, the increase of turbulent burning velocity is faster than that of the corresponding laminar burning velocity at constant equivalence ratio, suggesting that the kinetics effect is not the sole factor that results in the increase in turbulent burning velocity when hydrogen is added. The further analysis of flame surface characteristics and brush thickness indicates that hydrogen addition slightly decreases local flame surface density, but increases total flame surface area because of the increased flame brush thickness. The increase in flame brush thickness that results in the increase in total surface area may contribute to the faster increase in turbulent burning velocity, when hydrogen is added. Besides, the stretched local laminar burning velocity may be enhanced with the addition of hydrogen, which may also contribute to the faster increase rate of turbulent burning velocity. Both the variation in flame brush thickness and the enhancement in stretched local laminar burning velocity are due to the decreased fuel Lewis number when hydrogen is added. Therefore, the effects of fuel Lewis number and stretch should be taken into account in correlating burning velocity of turbulent premixed flames. (C) 2010 Professor T. Nejat Veziroglu. Published by Elsevier Ltd. All rights reserved.