Trimetallic alloys of Ni(0 6)Cu(0 4-x)Zn(x) (x = 0, 0 1 0 2 0 3 0 4) have been investigated as promising anode materials for low temperature solid oxide fuel cells (SOFCs) with composite electrolyte The alloys have been obtained by reduction of Ni(0 6)Cu(0) (4-x)Zn(x)O oxides, which are synthesized by using the glycine nitrate process Increasing the Zn content x decreases the particle sizes of the oxides at a given sintering temperature Fuel cells have been constructed using lithiated NiO as cathode and as prepared alloys as anodes based on the composite electrolyte Peak power densities are observed to increase with the increasing Zn addition concentration into the anode The maximum power density of 624 mW cm(-2) at 600 degrees C 375 mW cm(-2) at 500 degrees C has been achieved for the fuel cell equipped with Ni(0 6)Zn(0 4) anode A c impedance results show that the resistances dramatically decrease with increasing temperatures under open circuit voltage state Both cathodic and anodic interfacial polarization resistances increase with the amplitude of applied DC voltage Possible reaction process for H(2) oxidation reaction at anode based on composite electrolyte has been proposed for the first time The stability of the fuel cell with Ni(0 6)Cu(0 2)Zn(0 2) composite anode has been investigated The results indicate that the tri metallic Ni(0 6)Cu(0 4-x)Zn(x) anodes are considerable for low temperature SOFCs (C) 2010 Professor T Nejat Veziroglu Published by Elsevier Ltd All rights reserved