For the first time, an experimental three-dimensional reconstruction and visualization of stationary and transient flashing flow in a vertical pipe (47 mm diameter) is presented. The measurements have been performed by means of wire-mesh sensors. This type of sensor delivers two-dimensional void-fraction distributions in the pipe cross-section where it is mounted with a maximum sampling rate of 10,000 frames per second. A sampling rate of 1200 frames per second has been used in this work. Steam bubbles have been identified from the wire-mesh data and their complete three-dimensional reconstruction has been performed by taking into account the steam bubble velocity. For the estimation of the bubble velocity, two wire-mesh sensors positioned at a small axial distance from each other have been used. The velocity has been determined by cross-correlation of the two wire-mesh signals, by direct identification of the traveling time of the steam bubbles between the two sensors and by means of a drift-flux model. A comparison between the three methods of bubbles velocity measurement is reported. Stationary and time-dependent bubble size distributions have been derived. The stationary radial void-fraction profiles have been decomposed according to bubble size classes and compared with the results obtained with an equilibrium model. (c) 2006 Elsevier Ltd. All rights reserved.