Two DNA-block copolymers, poly(caprolactone)-DNA and poly(methyl metacrylate)-DNA, were synthesized by conjugation of a short single strand of DNA (12 or 22 mer) to a single reactive group at one end of the synthetic polymer. These polymers self-assemble in water, without the need of any cosolvent, forming micelle-like aggregates that were imaged by TEM. The solution behavior of the bioconjugated polymers was investigated by surface tension measurements. In the direction of dilution, the surface tension was measured using a down-scaled Wilhelmy plate method. To proceed in the reverse direction (concentration), we measured the surface tension of a sessile drop during its evaporation. This latter method was firstly validated using ionic and non-ionic surfactants, including polymeric surfactants. It was then applied to investigate the unimer to micelles transition of the DNA-block copolymers. In all cases, a reversible transition was observed demonstrating the existence of a critical micellar concentration, close to 0.01 mmol L-1 for all the conjugates. The CMC was only slightly influenced by the length of the hydrophilic DNA block. (C) 2012 Elsevier Inc. All rights reserved.