Irreversible membrane fouling is harmful for long-term operation of filtration. In this study, a novel anti-irreversible fouling polyvinylidene fluoride (PVDF) membrane was successfully fabricated using the wet phase separation methods. Nano-ZnO, with different dosages ranging from 6.7% to 26.7% (percentage of PVDF weight), was blended as an additive into the membrane matrix for the modification of the internal surfaces of membrane pores. A series of tests, such as filtration experiments, contact angle measurements, scanning electron microscope (SEM)/energy dispersive X-ray spectrometer (EDS) analyses and mechanical tests, were performed to characterize the modified membranes. The multi-cycle filtration experiments showed that the modified PVDF membranes demonstrated significant anti-irreversible fouling property. All the modified membranes achieved almost 100% water flux recovery after physical cleaning, whereas the raw membrane only reached 78% recovery. This promotion might be related to the increase of membrane hydrophilicity. The implantation of nano-ZnO into membrane inner surface (i.e., pore wall), as indicated by SEM/EDS tests, might be responsible for the enhancement of anti-irreversible fouling property. The water permeability of the modified membrane almost doubled by adding 6.7% nano-ZnO which was determined as the optimum dosage (within the dosage range in this study) for PVDF membrane modification. Additionally, the mechanical strength was found reinforced for modified membranes, which should also benefit the filtration application. (C) 2011 Elsevier B.V. All rights reserved.