In this study, aluminosilicate sol-gel coatings were deposited on Type 430 stainless steel by multiple spin casting cycles. Amorphous aluminosilicate coatings, 65 nm thick, were prepared from precursor solutions with 50, 100, and 500 mmol dm(-3) total concentrations of aluminum and silicon species (molar ratio of Al/Si = 1/4) by 10, 5, and 1 spin casting cycles, respectively. Although the obtained coatings had a similar composition with a molar ratio of Al/Si = 25/75, the coatings with increased density were formed by reducing the concentration of precursor solution. The pitting potentials of the coated stainless steels, measured by potentiodynamic polarization in 3.5% NaCl solution, increased remarkably (to 1.1 V vs Ag/AgCl) with a decrease in the concentration of precursor solution. Cyclic corrosion tests, consisting of 30 cycles of spraying of 5% NaCl solution at 35 degrees C for 2 h, drying at 60 degrees C for 4 h, and wetting at 50 degrees C and >95% relative humidity for 2 h, revealed highly improved corrosion resistance. Layer-by-layer sal-gel deposition using diluted precursor solutions is an effective way to obtain highly protective coatings. (C) 2013 The Electrochemical Society.