A systematic study of the dependence of ionic conductivity on the grain size of a lamellar block copolymer electrolyte was performed. A freeze-dried mixture of poly(styrene)-block-poly(ethylene oxide) and lithium bis-(trifluoromethylsulfonyl)imide salt was heated in steps from 29 to 116 degrees C and then cooled back to 29 degrees C with an annealing time ranging from 30 to 60 min at each temperature. Grain structure and ionic conductivity during these steps were quantified by in situ small-angle X-ray scattering and ac impedance spectroscopy, respectively. Conductivity depends both on grain structure and temperature. A normalization scheme to decouple the dependence of conductivity on temperature and grain structure is described. Ionic conductivity at a given temperature was found to decrease by a factor of 5.2 +/- 0.9 as the SAXS measure of grain size increased from 13 to 88 nm. The fact that in the system studied, large, well-formed lamellar grains are less conducting than poorly defined, small grains suggests a new approach for optimizing the transport properties of block copolymer electrolytes. Further work is necessary to confirm the generality of this finding.