The interest in bulk nanostructured materials (NSM), processed by methods of severe plastic deformation (SPD), is justified by their unique physical and mechanical properties. Equal-channel angular pressing (ECAP) is one of the methods of severe plastic deformation (SPD) that produces ultra fine-grained material. Due to the cyclic nature of the process, it is difficult to produce specimens with a high length to diameter ratio. Ratios of 6-7 have been reported in the literature to date. Longer specimens, however, are useful since the homogenous part is larger and the relative size of end effects is smaller. A new method was developed to obtain length to diameter ratios as high as 8-10. This new technique was developed using the multi-pass finite element simulation. The as-received alloy used in this study was the 6082 commercial Al-Mg-Si alloy. High strength and high ductility phenomenon that was found recently in materials after SPD were reached with the route C. The induced anisotropy of specimens after ECAP was monitored.