Hypereutectic ductile iron was cast in green sand moulds with four plates with thickness of 1.5, 2, 3 and 4 mm in each mould. Temperatures were measured in the 3 and 4 mm plate. The temperature curves showed that eutectic solidification was divided into two stages: primary and secondary eutectic solidification. The first stage, which was relatively short, had none or very little recalescence. Further under cooling, followed by reheating during recalescence, was necessary to initiate the second part of the eutectic solidification. Both the secondary under cooling and recalescence was larger in the 3 mm plates than in the 4 mm plates. All 1.5 mm plates contained carbides but the other plates solidified without carbides. Metallographic examination showed two populations of graphite nodules. A small group of nodules was larger than rest of the nodules. Color etching revealing the segregation of Si showed a higher Si content in the ferrite around the larger nodules compared to the ferrite around the rest of the nodules. This indicates that solidification took place along the following path: The solidification starts with nucleation and growth of primary graphite nodules. This probably starts during the filling of the mould. The primary nodules act as nuclei for austenite. As austenite easily nucleates on graphite the temperature will be the same for the 3 and 4 mm plate for the first part of the eutectic solidification. This first part of the solidification ends when concentration of carbon around austenite dendrites is too large and new nodules have to nucleate and grow. The larger under cooling for the 3 mm plates compared to the 4 mm indicates that the nucleation of new nodules is governed by kinetics even in very well inoculated melts.