Low-pressure powder injection molding was used to obtain AISI T15 high speed steel parts. The binders used were based on paraffin wax, low density polyethylene and stearic acid. The metals powders were characterized in terms of morphology, particle size distribution. The mixture was injected in the shape of square bar specimens to evaluate the performance of the injection in the green state, and then sintered. The samples were injected under the pressures of 0.4, 0.5 and 0.7Wa and at temperatures varying from 110 to 150 degrees C aiming the optimization of the process. The results of the variation of injection pressure were evaluated by measuring the density of the green parts. Debinding was carried out in two steps: first, the molded part was immersed in heptane to remove the major component of the binder and then heated to remove the remaining binder. A second step debinding and sintering were performed in a single step. This procedure shortened considerably the debinding and sintering time.