High levels of surface shear experienced during rolling, grinding or machining can cause 6000 series aluminium to develop an ultra-fine grained surface layers which dramatically increase susceptibility to filiform, corrosion (FFC) under paint films. In-situ Scanning Kelvin Probe (SKP) measurements in humid air are used to compare the kinetics and mechanism of FFC on abraded and lacquer-coated samples of high copper containing AA6111 and low level copper AA6016. FFC is initiated by applying a small volume of aqueous HCl to a penetrative defect on polyvinylbutyral (PVB) coated alloy samples prior to placement in a chamber maintained at constant humidity and temperature. The SKP is then repeatedly scanned over a fixed surface area to produce a time-lapse animation showing the dynamic evolution of localized free corrosion potential patterns. The spatial distribution of potential variation provides insight into the FFC mechanism and the numerical integration of areas of dissimilar potential provides a measure of the time-dependent area of coating delamination. Various possible FFC inhibition strategies are investigated for use under circumstances where removal of the surface layer prior to application of an organic (paint) coating is not feasible. The two strategies shown in this paper are the use of an anti-corrosion pigments based on an intrinsically conducting polymer called polyaniline. An anion-exchange pigment called hydrotalcite is also used.