In this paper, different methods for particle characterization were applied to 16 polydisperse fractions of quartz filtration sand obtained by sieving, with sieve diameters in the interval d(m) = 0359 to 2.415. For each fraction, volume diameter was measured and projected diameter and 2D shape factor were obtained using the scanned image of the projection of a large number of particles. The correlations between the volume diameter, projected diameter and 2D shape factor with sieve diameter were proposed. All of the correlations show linear dependence between the variables. The sphericity was determined for the fractions from packed-bed pressure drop measurements; from terminal velocity measurements using different correlations for the calculation of C-D, direct correlations for U-t and from direct empirical correlations. The sphericities obtained using different methods and correlations gave very different results. Both the sphericity and the 2D shape factor were shown to decrease with increase in particle sieve diameter. (C) 2014 Elsevier B.V. All rights reserved.