Interaction forces between a silica sphere and an alpha-alumina substrate at various pH values were measured by atomic force microscopy (AFM). As expected, at pH values of 10.8 and 10.2 when the surfaces are similarly charged, a repulsive force was observed. On the other hand, at pH values of 5.5, 6.4, and 8.6 when the surfaces sue oppositely charged, attractive forces mere observed, Experimental force vs separation distance curves were found to be in good agreement with theoretical predictions based on electrostatic and van der Waals interactions. Interestingly, when the force/radius values at a particular separation distance were plotted against pH, the transition from an attractive to a repulsive force occurred at pH 9.3, which is very close to the point of zero charge (pzc) of alpha-alumina as determined from electrophoresis experiments. These results suggest that AFM force measurements can be used to estimate the pzc of materials. This method may be of particular significance for soluble salt minerals where conventional electrophoretic measurements are not possible at high ionic strengths. Finally, results from transmittance studies further confirmed the interaction between silica and alpha alumina particles in suspensions at various pH values as would be expected based on the results from atomic force microscopy measurements.