A new encapsulation method for organic solar cells has been tested on flexible solar modules and cells embedded in polyurethane, sandwiched between a tempered glass plate and a polycarbonate plate. Panels, each containing 10 organic solar modules/cells, were fabricated and installed for outdoor exposure in eight different countries for 41/2 months. In order to minimize potential deviations in procedures and equipment, one person was responsible for the fabrication, installation and initial and final IV-measurements of the panels using the same equipment for all measurements and calibrations. The encapsulated modules/cells showed significantly reduced degradation compared with previous studies, with final average efficiencies around 40% of the original after 41/2 months outdoor exposure. Photodegradation was furthermore found not to be the primary source of degradation. (C) 2011 Elsevier B.V. All rights reserved.