The phenomenon of non-uniform flow distribution and its influence on thermal performance within a traditional solar thermal collector is well known. Its effect on the photovoltaic conversion of a hybrid photovoltaic/thermal (PV/T) collector however has received little attention. In this study an investigation has been carried out to determine what effect flow distribution will have on the photovoltaic yield of a BIPV/T collector of various size. A three step numerical analysis was conducted to model flow distribution, temperature variation, and photovoltaic yield for a PV/T collector of various design (manifold sizes), geometric shape (aspect ratio), and operating characteristics (mass flow rate and flow direction in manifolds) in order to vary flow uniformity within the collector. The results revealed that flow distribution within the collector will have a significant influence on the photovoltaic performance of a hybrid PV/T collector. For the scenario where flow distribution was most uniform, photovoltaic performance was improved by over 9% in comparison to a traditional photovoltaic (PV) collector operating under the same conditions. For poor flow however, performance was only improved by approximately 2%. Parameters found to influence flow distribution include the manifold to riser pipe ratio where a ratio of 4:1 was found to be ideal and that increasing to a 6:1 ratio offered negligible improvement. Additionally it was found that array geometry (characterised by its aspect ratio in this study) plays an important role on both flow distribution and photovoltaic yield. This study has identified that the optimal mass flow rate is dependent on the shape or aspect ratio of the array. (C) 2012 Elsevier Ltd. All rights reserved.