Phosphorus (P) atomic layer doping in SiGe is investigated at temperatures between 100 degrees C to 600 degrees C using a single wafer reduced pressure chemical vapor deposition system. SiGe(100) surface is exposed to PH3 at different PH3 partial pressures by interrupting SiGe growth. The impact of the SiGe buffer/cap growth condition (total pressure/SiGe deposition precursors) on P adsorption, incorporation, and segregation are investigated. In the case of SiH4-GeH4-H-2 gas system, steeper P spikes due to lower segregation are observed by SiGe cap deposition at atmospheric (ATM) pressure compared with reduced pressure (RP). The steepness of P spike of similar to 5.7 nm/dec is obtained for ATM pressure without reducing deposition temperature. This result may be due to the shift of equilibrium of P adsorption/desorption to desorption direction by higher H-2 pressure. Using Si2H6-GeH4-H-2 gas system for SiGe cap deposition in RP, lowering the SiGe growth temperature is possible, resulting in higher P incorporation and steeper P profile due to reduced desorption and segregation. In the case of Si2H6-GeH4-H-2 gas system, the P dose could be simulated assuming a Langmuir-type kinetics model. Incorporated P shows high electrical activity, indicating P is adsorbed mostly in lattice position. (C) 2013 Elsevier B.V. All rights reserved.