The effect of implantation order and post-annealing temperature on surface blistering of H and He co-implanted germanium was investigated in the samples implanted with H and He in different orders (H first then He or He first then H). Itwas found that blisterswere easily formed in H-alone sample after annealing at 350 degrees C. However, with the increasing annealing temperature, the blistering phenomenawere inclined to occur in the co-implanted samples, especially in He-first sample. The different behaviors of blister formation were closely correlated with the thermal stability of He implantation-induced damage. For lowtemperature annealing, most of the implanted He atomswere localized at the original site as implanted and the diffusion of Hewas efficiently suppressed, thus the blistering mainly originated from the platelets which were pressurized by implanted H. In consequence, blisters were more easily formed in H-alone sample in which the implantation dose of H was relatively higher than the co-implanted samples. However, for higher temperature annealing, the enhanced blistering behavior of co-implanted samples was attributed to an increasing contribution of He to the internal pressure of H-platelets. Compared to the He-first sample, the formation of large defect clusters with high vacancy/hydrogen ratio in the H-first sample may retard the blistering phenomenon. (c) 2013 Elsevier B.V. All rights reserved.