To enhance the removal of oil contaminants from water, polyurethane foam structure was modified by integrating cloisite 20A nanoclay into it. Pure and modified polyurethane foams (nanocomposite adsorbents) were then characterized using scanning electron microscopy, X-ray diffraction, and Fourier transform infrared spectroscopy tests. Optimum weight fraction of the added cloisite 20A to the foam structure was 3 wt%, improving the sorption capacity up to 16% and oil removal efficiency up to 56% in water-oil system. The reusability feature of blank polyurethane and nanocomposites with 3 wt% and 4 wt% of cloisite 20A nanoclay was studied through chemical regeneration by toluene and petroleum ether. In the case of structurally modified polyurethane foams with nanoclay (nanocomposites), chemical regeneration reduced the oil removal efficiency, but improved the adsorption capacity in the range of low to medium oil initial concentration and reduced it in high oil initial concentrations. A comparison between the obtained adsorption data and adsorption isotherm models, including Langmuir, Freundlich and Redlich-Peterson, showed a good agreement with Langmuir and Redlich-Peterson models. (C) 2014 Elsevier B.V. All rights reserved.