Herein, the poorly water-soluble drug, Tamoxifen (Tmx), was loaded in the amphipathic matrix of human serum albumin (HSA) nanoparticles by a modified desolvation method. In order to enhance the drug loading (DL) and drug entrapment efficiency (DEE) (<2% and 10%, respectively), ultrasonication of Tmx-HSA mixture was performed prior to desolvation process. Tmx loading and entrapment efficiency were optimized by employment of the response surface methodology (RSM)-central composite design (CCD) of experiments. Under the optimum conditions of 1.59 mg Tmx/ml concentration, 7.76 pH and 5 h incubation of HSA-Tmx, the DL of 6.7% and DEE of 74% are achievable. Particles with the average size of 195 nm, zeta potential of -21 mV and polydispersity index of 0.09 were produced under these conditions. A more sustained Tmx release behavior was observed from polyethylene glycol (PEG) conjugated nanoparticles in comparison to the non-PEGylated ones. The short-term stability investigation showed no alteration in physicochemical properties of nanoparticles at 4 and 37 C, but small increase in nanoparticles size was observed after three months of storage at room temperature. This is the first report for efficient production of a Tmx delivery system based on HSA nanoparticles. (C) 2013 The Institution of Chemical Engineers. Published by Elsevier B.V. All rights reserved.