In order to increase the lifetime and performance of the molten carbonate fuel cell, it is compulsory to control the corrosion and dissolution of the state of the art porous nickel oxide cathode. A protective coating constituted by more stable oxides appears to be the best approach. Previous research on CeO2 coatings obtained by DC reactive magnetron sputtering to protect the Molten carbonate fuel cell cathode gave promising results but it was necessary to improve the coating adhesion. In this paper Atomic Layer Deposition, producing high quality, homogeneous and conformal layers, was used to obtain thin layers of CeO2 (20 nm and 120 nm) deposited over porous nickel. CeO2-Ni coated samples were tested as cathodes in Li2CO3-K2CO3 (62-38 mol %) eutectic mixture under standard cathode atmosphere (CO2/air 30:70 vol. %). Structural and morphological characterizations of the nickel coated cathode before and after electrochemical tests in the molten carbonate melt are reported together with the Open Circuit Potential evolution all over 230 h for both the bare porous nickel and the CeO2-coated samples. (C) 2014 Elsevier Ltd. All rights reserved.