Fuel, Vol.149, 26-33, 2015
Electrooxidation treatment for removal of emerging pollutants in wastewater sludge
Management of wastewater sludge continues to pose a challenge as its generation is rising as a result of an increase in wastewater treatment and because its quality varies widely. Lately, emerging pollutants have gained importance based on their persistence and potential risk once they enter the environment. Different treatment processes have been proposed to reduce their concentration, such as electrooxidation. Electrooxidation using boron doped diamond electrodes has properties that make them suitable for a wide variety of applications, including wastewater and sludge. Electrooxidation was applied to sludge from a wastewater treatment plant receiving industrial discharges located in Toluca, Mexico. Different pH and current densities were tested at the laboratory and, based on soluble chemical oxygen demand (sCOD) reduction, operating conditions were set at a pH of 3 and a current density of 40 mA cm(-2) during 1 h. Oxidation of organic matter was limited by the concentration of solids during treatment as phased separation (flotation) occurred due to gas generation and additional tests were performed to overcome this situation. 4,4'-(Propane-2,2-diyl) diphenol, Nonylphenol, and 5-chloro-2-(2,4-dichlorophenoxy) phenol were removed by 73%, 89%, and 82% under improved test conditions. Sludge volatile solids were degraded 23% and total COD 27%. Overall, the proposed process represents a promising technology to reduce emerging pollutants in wastewater sludge. (C) 2014 Elsevier Ltd. All rights reserved.