Surface wettability of terminally anchored hydrophilic polymer brush layers on polyamidesilicon (PASi) surfaces was evaluated with respect to surface topography at the nanoscale. Hydrophilic polyvinylpyrrolidone (PVP) and polyacrylamide (PAAm) brush layers were synthesized via graft polymerization onto a PASi surface previously activated by surface treatment with atmospheric pressure plasma. Hydrophilicity (or wettability) of the PA substrate, as quantified by the free energy of hydration, was increased upon surface coverage with the PVP and PAAm brush layers by 13-24% (-101.4 to -111.3 mJ/m(2)) and 19-37% (-106.1 to -122.4 mJ/m(2)), respectively. Surface hydrophilicity increased with both increasing surface roughness (0.55-2.89 nm and 1.54-5.84 nm for PVP and PAAm, respectively) and polymer volume (1.3 x 10(6)7.3 x 10(6) nm(3)/mu m(2) and 3.3 x 10(6)2.8 x 10(7) nm(3)/mu m(2) for PVP and PAAm surfaces, respectively). The present study suggests that a specific level of surface wettability can be attained by tailor-designing the polymer brush layers physicochemical characteristics (e.g., surface roughness, wettability, and polymer water affinity) by adjusting surface topography and surface chemistry, which are controlled by surface activation and polymerization conditions. The above indicates that there is merit in structuring various surfaces with hydrophilic brush layers to increase surface wettability in membrane filtration, biomedical devices, and lubrication applications. (C) 2014 Elsevier Inc. All rights reserved.