Supported lipid bilayers (SLBs) are often formed by spontaneous vesicle rupture and fusion on a solid surface. A well-characterized rupture mechanism for isolated vesicles is pore nucleation and expansion in the solution-exposed nonadsorbed area. In contrast, pore formation in the adsorbed bilayer region has not been investigated to date. In this work, we studied the detailed mechanisms of asymmetric rupture of giant unilamellar vesicles (GUVs) adsorbed on glass using fluorescence microscopy. Asymmetric rupture is the pathway where a rupture pore forms in a GUV near the edge of the glassbilayer interface with high curvature and then expansion of the pore yields a planar bilayer patch. We show that asymmetric rupture occasionally resulted in SLB patches bearing a defect pore. The defect formation probability depended on lipid composition, salt concentration, and pH. Approximately 40% of negatively charged GUVs under physiological conditions formed pore-containing SLB patches, while negatively charged GUVs at low salt concentration or pH 4.0 and positively charged GUVs exhibited a low probability of defect inclusion. The edge of the defect pore was either in contact with (on-edge) or away from (off-edge) the edge of the planar bilayer. On-edge pores were predominantly formed over off-edge defects. Pores initially formed in the glass-adsorbed region before rupture, most frequently in close contact with the edge of the adsorbed region. When a pore formed near the edge of the adsorbed area or when the edge of a pore reached that of the adsorbed area by pore expansion, asymmetric rupture was induced from the defect site. These induced rupture mechanisms yielded SLB patches with an on-edge pore. In contrast, off-edge pores were produced when defect pore generation and subsequent vesicle rupture were uncoupled. The current results demonstrate that pore formation in the surface-adsorbed region of GUVs is not a negligible event.