A series of nickel laterite ores with different calculated amounts of anhydrous sodium sulphate were prepared by physical blending or sodium sulphate solution impregnation. The reduction of the prepared nickel laterite ore by H-2 was carried out in a fluidised-bed reactor with provisions for temperature and agitation control, and the magnetic separation of the reduced ore was performed using a Davis tube magnetic separator. The mineralogical properties of the raw laterite ore, reduced ore and magnetic concentrate were characterised using ICP, TG-DSC, N-2 adsorption, X-ray diffraction and optical microscopy. The catalytic activity of sodium sulphate was also studied by using Hydrogen temperature-programed reduction. The experimental results indicate that Na2SO4 could overcome the kinetic problems faced by the laterite ore and that it exhibited noticeable catalytic activity only if the temperature reached at least 750 degrees C. This high temperature accelerated the crystal phase transition of the silicate minerals and increased the utilisation of H-2. In comparing the results from the two different methods for adding Na2SO4, the nickel content and recovery of the magnetic concentrate were increased by using the impregnation method rather than the physical blending method and the increasing amount of sodium sulphate assisted in the further beneficiation of nickel. The partial pressure of H-2 and the reducing time also affected the reduction process of the iron oxides. The results of the microscopic study indicated that the formation of a Fe-S solid solution, which was derived from the SO2 sulphide reduction of FeO, was conducive to mass transfer and accelerated the coalescence of metallic ferronickel particles. For the nickel laterite ore, under the synergistic effect of sodium sulphate and hydrogen, a nickel content and nickel recovery of 6.38% and 91.07% were obtained, respectively, with high product selectivity. (C) 2013 Elsevier Ltd. All rights reserved.