The effect of activation gas on the Fischer-Tropsch synthesis (FTS) performance of copper and potassium promoted precipitated iron-based catalysts was investigated in an earlier study [Catal. Lett. 144 (2014) 1624-1635]. In that study, CO and syngas (H-2/CO=0.7) activation methods were tested after varying the copper promoter loading (0, 2, and 5%, atomic ratios relative to iron). At similar CO conversion level, the selectivities for the CO-activated catalysts were identical for the various copper loaded catalysts, whereas for the syngas activated catalysts, light hydrocarbon (methane and C-2-C-4) selectivities decreased and higher hydrocarbon (C-5+) selectivities increased with increasing copper loading. To understand the reason for that behavior, the catalyst samples were characterized by XANES/EXAFS spectroscopy following each activation procedure before and after exposure to FTS conditions. Cu K-edge normalized XANES results indicate that for the syngas activated catalyst copper is present primarily in the Cu1+ state, whereas for CO activated catalyst the copper is more reduced (greater fraction in the Cu-0 state). The Cu1+ in the syngas activated catalyst behaved like K1+; therefore, the C-5+ selectivity was enhanced and light hydrocarbon selectivity was suppressed. (C) 2015 Elsevier B.V. All rights reserved.