Tantalum oxynitride thin films were produced by magnetron sputtering. The films were deposited using a pure Ta target and a working atmosphere with a constant N-2/O-2 ratio. The choice of this constant ratio limits the study concerning the influence of each reactive gas, but allows a deeper understanding of the aspects related to the affinity of Ta to the non-metallic elements and it is economically advantageous. This work begins by analysing the data obtained directly from the film deposition stage, followed by the analysis of the morphology, composition and structure. For a better understanding regarding the influence of the deposition parameters, the analyses are presented by using the following criterion: the films were divided into two sets, one of them produced with grounded substrate holder and the other with a polarization of -50 V. Each one of these sets was produced with different partial pressure of the reactive gases P(N-2 + O-2). All the films exhibited a O/N ratio higher than the N/O ratio in the deposition chamber atmosphere. In the case of the films produced with grounded substrate holder, a strong increase of the O content is observed, associated to the strong decrease of the N content, when P(N-2 + O-2) is higher than 0.13 Pa. The higher Ta affinity for O strongly influences the structural evolution of the films. Grazing incidence X-ray diffraction showed that the lower partial pressure films were crystalline, while X-ray reflectivity studies found out that the density of the films depended on the deposition conditions: the higher the gas pressure, the lower the density. Firstly, a dominant beta-Ta structure is observed, for low P( N-2 + O-2); secondly a fcc-Ta(N, O) structure, for intermediate P(N-2 + O-2); thirdly, the films are amorphous for the highest partial pressures. The comparison of the characteristics of both sets of produced TaNxOy films are explained, with detail, in the text. (C) 2015 Elsevier B.V. All rights reserved.