In the search for greater efficiency and storage capacity improvements in solar energy concentration plants, a new concept for fluid transfer was proposed. This concept consists of a dense suspension of SiC particles (d(p) = 6.4 x 10(-5) m) that is air fluidized, which allows operation at higher temperatures than the fluids currently used, such as molten salts, water, oils and air. The suspension, as a fluid, also provides energy storage. The upward flow of the SiC-air suspension inside a steel tube is achieved using a circulating fluidized bed dense regime. Concentrated solar radiation impinges the walls of the tube, increasing the temperature of the granular material up to 200-250 degrees C. The system in this study is part of a prototype in the PROMES Laboratory in France. Maintaining low fluidization velocities guarantees high solid fractions throughout the tube (0.28-0.45). This study simulates heat transfer between the wall and the suspension using computational fluid dynamics (CFD) (ANSYS-Fluent 14.5) for different operating conditions. The Euler-Euler model is used as the multi -phase model. The average experimental temperature in the emulsion at the exit of the heat transfer zone compares well with the temperature obtained in the CFD simulation. The global heat transfer coefficients obtained in the simulation are in good agreement with those obtained experimentally for all operating conditions. These results show that the developed simulation approach is a good representation of the real process and provides relevant information related to the movement of particles in the tube and its relation to heat transfer in the prototype. (C) 2015 The Institution of Chemical Engineers. Published by Elsevier B.V. All rights reserved.