In this paper, we present a unique process chain for the production of single-walled carbon nanotubes (SWCNT) and document the relationship between the process parameters in gas phase production, the dispersibility of SWCNTs in aqueous solutions of sodium cholate and their properties. SWCNTs were prepared by a "floating catalyst" method using a solution of ferrocene in ethanol as precursor. Production rates in the range from 5 to 20 mg/h were achieved by using an optimized riser reactor design, which enables reduction of undesired wall-sticking of the catalyst particles and SWCNTs. Products featuring iron catalyst contents less than 30 wt% were obtained for low precursor concentrations in combination with short residence time in the reactor. Transmission electron microscopy (TEM) and statistical Raman analyses of the products reveal that the SWCNTs exhibit a diameter distribution ranging from 0.5 to 2.0 nm. Processing conditions, including precursor concentration, residence time, etc. were found to have only a slight impact on the mean geometric SWCNT diameter. Sonication based post-processing of the as-prepared SWCNTs in aqueous solutions of sodium cholate leads to an effective individualization of SWCNTs as proven by atomic force microscopy (AFM), 3D fluorescence spectroscopy, and by multi-wavelength analytical ultracentrifugation (AUC). Overall, the dispersibility of the non-purified SWCNTs in a 2 wM aqueous solution of sodium cholate increases as the ferrocene partial pressure is decreased and, in turn, the catalyst concentration is reduced in the gas phase. Statistical Raman spectroscopy performed with the SWCNTs reveals that more than 75% of the produced carbon species are SWCNTs and that about 2/3 are semiconducting. (C) 2015 Elsevier Ltd. All rights reserved.