The temporal and spatial growth behaviour of protein crystals, subject to different cooling strategies in protein crystallisation was investigated. Although the impact of temperature and cooling rate on crystal growth of small molecules was well documented, much less has been reported on their impact on the crystallisation of proteins. In this paper, an experimental set-up is configured to carry out such a study which involves an automatic temperature controlled hot-stage crystalliser fitted with a real-time imaging system. Linbro parallel crystallisation experiments (24-well plate) were also conducted to find the suitable initial conditions to be used in the hot-stage crystallisation experiments, including the initial concentration of HEW lysozyme solutions, precipitate concentration and pH value. It was observed that fast cooling rates at the early stage led to precipitates while slow cooling rates produced crystal nuclei, and very slow cooling rates, much smaller than for small molecules are critical to the growth of the nuclei and the crystals to a desired shape. The interesting results provide valuable insight as well as experimental proof of the feasibility and effectiveness of cooling as a means for achieving controlled protein crystallisation, compared with the evaporation approach which was widely used to grow single large crystals for X-ray diffraction study. Since cooling rate control can be easily achieved and has good repeatability, it suggests that large-scale production of protein crystals can be effectively achieved by manipulating cooling rates. (C) 2015 The Chemical Industry and Engineering Society of China, and Chemical Industry Press. All rights reserved.