Coking coals with different rank and maceral compositions have been weathered, and their fluidity has been determined through high-temperature rheometry. The pristine and weathered coals were blended with carbonaceous additives comprised of coal tar, diesel fuel, high-density polyethylene, sugar beet roots, lignin, and bio-oil in order to produce blends with optimum fluid characteristics. The addition of only 3 wt % coal tar to a high-rank coal weathered for 6 months completely restored its fluid properties, and the addition of 3 wt % diesel fuel was able to restore the fluidity of the coal but only after shorter weathering periods (4 months). However, the strength parameter RI (particles > 0.6 mm) of the semicokes obtained from these blends at 700 degrees C was lower than that of the pristine coal by 3%. Biomass additives such as sugar beet roots and lignin were found to reduce the fluidity of a weathered coal with medium-volatile-matter content (25 wt % dry ash free (daf)) to levels similar to those encountered in good coking coals. Although sugar beet roots reduced the strength of the semicoke obtained from the blend, the blend with lignin produced a semicoke with strength similar to that of the pristine coal. The lower volatility matter content in lignin compared to sugar beet roots and its high oxygen content (similar to 25 wt %) could limit fissure formation in the semicoke and facilitate the cohesion with the oxidized coal matrix, respectively.