Decarboxylation of fatty acids is a path to fuel-range hydrocarbons from renewable plant and seed oils. Pt/C is an effective hydrothermal catalyst for decarboxylating saturated fatty acids without added hydrogen, but it has shown low selectivity and activity for decarboxylating unsaturated fatty acids, which are prevalent in plant oils from soy and algae. To develop better decarboxylation catalysts, we compared three different Sn containing alloys, Pt3Sn/C, PtSn/C, and PtSn3/C, to Pt/C by performing batch reactions in liquid water at 350 degrees C for two hours with stearic (C18:0), oleic (C18:1), and linoleic (C18:2) acids. Pt/C gave yields of 0.70 +/- 0.05, 0.16 +/- 0.03, and 0.083 +/- 0.009 for the C-17 alkane, but none of the direct decarboxylation products (i.e., C-17 alkenes), for the oleic and linoleic acid feeds. Stearic acid was the major byproduct from the unsaturated fatty acids. In contrast, the PtSnx/C catalysts provided two to three times higher C-17 alkane yields at identical conditions. Experiments in D2O showed that water molecules were a source of hydrogen for saturation of the fatty acids. These results show that PtSnx alloys give better performance than Pt alone for the hydrothermal conversion of renewable fatty acids to fuel range hydrocarbons. (C) 2015 Elsevier Ltd. All rights reserved.