Tank discharge gas/vapor flow problems are frequently encountered in both practice and design. To perform this type of design calculation, the first step is to identify whether the flow is choked or not through a trial-and-error solution of an equation for adiabatic flow with friction from a reservoir through a pipe. Developing a direct method without any trial-and-error to identify a choking condition would be helpful for expediting the flow calculations. This paper presents an easy and quick method to identify the choking of gas flow for an emergency relief system consisting of a rupture disk and vent piping. This greatly simplifies the design calculations. The proposed method for validating the venting adequacy of existing ERS circumvents the iteration calculation and the use of Lapple charts. Three case studies for the design of vent piping for rupture disks support the proposed method. (c) 2015 Elsevier Ltd. All rights reserved.